subject
Physics, 24.07.2019 13:00 casie65

15. using 1/2-inch emt and a hand bender, you want to make a bend with a 14-inch stub-up. how far from the end of the conduit should you put the mark that will line up with the bender arrow? a. 19 inches b. 9 inches c. 14 inches d. 16 5/8 inches

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 15:00
You hang a book bag on a spring scale and place the bag on a platform scale so that the platform scale reads 23.7n and the spring scale reads 13.8n. what is the magnitude of the force that earth exerts on the bag?
Answers: 1
question
Physics, 22.06.2019 16:00
Amichelson interferometer operating at a 600 nm wavelength has a 3.02-cm-long glass cell in one arm. to begin, the air is pumped out of the cell and mirror m2 is adjusted to produce a bright spot at the center of the interference pattern. then a valve is opened and air is slowly admitted into the cell. the index of refraction of air at 1.00 atm pressure is 1.00028.how many bright-dark-bright fringe shifts are observed as the cell fills with air?
Answers: 1
question
Physics, 22.06.2019 19:30
A47.2 g block of copper whose temperature is 480 k is placed in an insulating box with a 91.8 g block of lead whose temperature is 200 k. (a) what is the equilibrium temperature of the two-block system? (b) what is the change in the internal energy of the two-block system between the initial state and the equilibrium state? (c) what is the change in the entropy of the two-block system? the heat capacities of copper and lead are 386 j/kgยทk and 128 j/kgยทk, respectively.
Answers: 1
question
Physics, 22.06.2019 21:10
Two masses are connected by a rope that hangs over a pulley as shown below. the pulley is a uniform cylinder of radius ํ‘…=0.381meters and mass ํ‘€=3.1ํ‘˜ํ‘”. initially ํ‘š"is on the ground and ํ‘š#rests 2.5 meters above the ground. if the system is released, use conservation of energy to determine the speed of ํ‘š#just before it strikes the ground. assume the pulley bearing is frictionless.
Answers: 2
You know the right answer?
15. using 1/2-inch emt and a hand bender, you want to make a bend with a 14-inch stub-up. how far fr...
Questions
question
Mathematics, 04.04.2020 22:47
question
Mathematics, 04.04.2020 22:47
question
English, 04.04.2020 22:47
question
Mathematics, 04.04.2020 22:47
question
Mathematics, 04.04.2020 22:47
Questions on the website: 13722360