SAT, 29.12.2021 03:20 IntellTanito

Select the correct answer. Which is true regarding ac current? a. The electrons move back and forth. B. The +/- polarity is constant. C. It is common in portable devices. D. It can only produce low voltages.

Answers: 3

Show answers

Another question on SAT

SAT, 23.06.2019 07:00

After rain, water soaks into the ground and is added to the groundwater. this process is known as a. groundwater pollution. b. groundwater recharge. c. groundwater recycling. d. groundwater filtration.

Answers: 1

Answer

SAT, 25.06.2019 07:00

Which characteristic demonstrates a healthy self-esteem? accepts others does not listen well seeks constant approval frustrates easily

Answers: 3

Answer

SAT, 27.06.2019 06:00

Guys plz and say a best answer i will give 15 points how we should prepare for a scholarship exam

Answers: 2

Answer

SAT, 27.06.2019 10:00

Tissues that carry food water and nutrients throughout the plant

Answers: 1

Answer

You know the right answer?

Select the correct answer. Which is true regarding ac current? a. The electrons move back and forth....

Questions

Engineering, 11.07.2019 03:10

The function of the oil separator in vapour compression refrigerator is (a) lubricate the compressor (b) reduce heat transfer efficiency (c) prevent...

Engineering, 11.07.2019 03:10

While checking the supply voltage, each phase should be the nameplate motor voltage rating. (a) 3% (b) 20% (c) 15% (d) 10%...

Engineering, 11.07.2019 03:10

Differentiate between accuracy and precision....

Engineering, 11.07.2019 03:10

Acylinderical specimen of stainless steel having a diameter of 0.505 in and a gauge length of 2.000 in is pull ength of the gauge section 2.30" with t...

Engineering, 11.07.2019 03:10

Consider the steady-state flow in a combustion chamber where heat is added by burning fuel. neglect friction and consider that the thermodynamic prope...

Engineering, 11.07.2019 03:10

Aregulator will be able to perform its function of sustaining evaporator pressure at a lower value whenever the compressor suction pressure enough to...

Engineering, 11.07.2019 03:10

The material of pipe line for a system of refrigeration should (a) aluminium (b) copper (c) steel (d) brass...

Engineering, 11.07.2019 03:10

While capacity control is usually desirable, the potential -up problems is high. (a) water (b) pressure (c) oil (d) none of the above...

Engineering, 11.07.2019 03:10

An end milling operation is being carried out on a 500 mm long and 80 mm wide aluminum alloy block to make a slot of 50 mm in width and 3 mm in depth....

Engineering, 11.07.2019 03:10

What is error? give and define two types of errors. what are the causes of each type of these errors...

Engineering, 11.07.2019 03:10

Give 3 reasons for the importance of instrumentation and measurement system in industrial applications....

Engineering, 11.07.2019 03:10

Evaporator pressure attempts to push . (a) condenser coil (b) hot gas line (c) valve disc (d) none of the above...

Engineering, 11.07.2019 03:10

Acar's engine consumes 110 kw of power from its fuel, converts some of that to useful shaft power, and rejects 85 kw of heat. what is the engines effi...

Engineering, 11.07.2019 03:10

Find the knot vector for a quintic (k = 6) b-spline created from nine control points....

Engineering, 11.07.2019 03:10

In an experiment on a 90 v-notch the flow is collected in a 0.9 m diameter vertical cylindrical tank. it is found that the depth of water in the tank...

Engineering, 11.07.2019 03:10

An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure difference between the pressure tapping points is 35...

Engineering, 11.07.2019 03:10

Find five control points which form a bezier curve with a loop in it. write the equation plot the curve, and plot the control points....

Engineering, 11.07.2019 03:10

Purpose of investigating the thermodynamic relations between property parameters is (a) to understand them better or (b) to calculate more accurately...

Engineering, 11.07.2019 03:10

Compressibility factor, z, will approach to 1 at (a) low pressure and low temperature, (b) low pressure and high temperature, (c) high pressure and hi...

Engineering, 11.07.2019 03:10

Coefficients, i. e. a and b of van der waals equation can be determined by (a) critical condition of the gas, (b) curve fit of p-v-t experimental data...