Engineering, 11.07.2019 03:10 sonnyboi2305
An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure difference between the pressure tapping points is 35 kn/m2. the flow rate of water through the meter is obtained by measuring the times required to collect a certain quantity of water in a tank and such measurements gave an average quantity of 580 litres of water collected in 2 min. determine the coefficient of discharge of the meter.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10
What is the main objective of using reheat rankine cycle?
Answers: 3
You know the right answer?
An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure dif...
Questions
History, 18.11.2020 23:20
Mathematics, 18.11.2020 23:20
Business, 18.11.2020 23:20
Mathematics, 18.11.2020 23:20
Mathematics, 18.11.2020 23:20
Physics, 18.11.2020 23:20
Mathematics, 18.11.2020 23:20
Mathematics, 18.11.2020 23:20
History, 18.11.2020 23:20
English, 18.11.2020 23:20
Chemistry, 18.11.2020 23:20
Health, 18.11.2020 23:20
Health, 18.11.2020 23:20
