Physics, 14.10.2021 04:10 laniyasontee

C 0 0 Suppose the initial position of an object is zero, the starting velocity is 3 m/s and the final velocity was 10 m/s. The
object moves with constant acceleration. Which part of a velocity vs. time graph can be used to calculate the
displacement of the object?
O the area of the rectangle under the line
O the area of the rectangle above the line
the area of the rectangle plus the area of the triangle under the line
O the area of the rectangle plus the area of the triangle above the line

C 0 0

Suppose the initial position of an object is zero, the starting velocity is 3 m/s and the f

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Asap time is ! best answer gets compose at least one well-developed paragraph on the following: define the term concurrent powers, and give an example of a concurrent power of government.

Answers: 1

Answer

Physics, 22.06.2019 13:20

It is reasonable to assume that the bulk modulus of blood is about the same as that of water (2.2 gpa). as one goes deeper and deeper in the ocean, the pressure increases by 10000 pa for every meter below the surface. if a diver goes down 80.0 m in the ocean, by how much does each cubic centimeter of her blood change in volume? give the answer in cubic centimeters (actually one cubic centimeter equals one milliliter).

Answers: 2

Answer

Physics, 22.06.2019 16:30

The air in an automobile tire with a volume of 2.60 ft3 is at 70°f and 21 psig. determine the amount of air that must be added to raise the pressure to the recommended value of 30 psig. assume the atmospheric pressure to be 14.6 psia and the temperature and the volume to remain constant. the gas constant of air is ru = 53.34ft⋅lbflbm⋅r(1 psia144 lbf/ft2) = 0.3704 psia⋅ft3lbm⋅r the amount of air that must be added to raise the pressure is lbm

Answers: 3

Answer

Physics, 23.06.2019 01:30

When a lead acid car battery is recharged by the alternator, it acts essentially as an electrolytic cell in which solid lead(ii) sulfate is reduced to lead at the cathode and oxidized to solid lead(ii) oxide at the anode. suppose a current of is fed into a car battery for seconds. calculate the mass of lead deposited on the cathode of the battery.

Answers: 3

Answer

You know the right answer?

C 0 0 Suppose the initial position of an object is zero, the starting velocity is 3 m/s and the fi...

Questions