Physics, 02.09.2021 21:50 martinez78

Skeletal System Diseases and Disorders Portfolio Portfolio Overview

This writing assessment will help you apply the function of the skeletal system's anatomical structures to the diseases or disorders of the system.

Portfolio Goal

Write a one-page paper consisting of 250 words.

Portfolio Details

Write a paper describing a disease or disorder of the skeletal system. Be sure to include the following information:

Define the disease or disorder and explain its typical cause.
Describe the signs and symptoms of the disease or disorder.
Describe the anatomical structures involved or that can be involved in this disease or disorder.
Describe the treatment.
Describe any ways this disease or disorder might be prevented.
Briefly discuss whether this disease or disorder is related to a specific stage of the lifespan or whether a specific stage of life impacts this disease.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 04:30

In a voltaic cell, electrons flow from the (positive/negative) to the (positive/negative) terminal.

Answers: 1

Answer

Physics, 22.06.2019 10:30

Air is to be preheated by hot exhaust gases in a cross-flow heat exchanger before it enters the furnace. air enters the heat exchanger at 95 kpa and 20°c at a rate of 0.6 m^3/s. the combustion gases (cp = 1.10 kj/kg°c) enter at 160°c at a rate of 0.95 kg/s and leave at 95°c. determine the rate of heat transfer to the air and its outlet temperature.

Answers: 2

Answer

Physics, 22.06.2019 16:30

The air in an automobile tire with a volume of 2.60 ft3 is at 70°f and 21 psig. determine the amount of air that must be added to raise the pressure to the recommended value of 30 psig. assume the atmospheric pressure to be 14.6 psia and the temperature and the volume to remain constant. the gas constant of air is ru = 53.34ft⋅lbflbm⋅r(1 psia144 lbf/ft2) = 0.3704 psia⋅ft3lbm⋅r the amount of air that must be added to raise the pressure is lbm

Answers: 3

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Skeletal System Diseases and Disorders Portfolio Portfolio Overview

This writing asses...

Questions