Physics, 13.11.2019 23:31 randyg0531

Explain why the life cycle of a star can be compared to the life style of a human

Answers: 2

Show answers

Answers

A star is born when clouds of dust and elements are gathered together in a certain space due to gravity, more and more mass and therefore pressure builds. When the pressure becomes enough to overcome the electronic repulsive force between two hydrogen nuclei, they are forced together and massive amounts of energy are given off forming helium atoms. This energy is then used to fuse other nuclei together. This could be compared to the way human life starts, where instead of 2 nuclei joining together to start a life cycle, two gametes, or sex cells are joined together. Also at the start of both a star and persons life, we are weak and we gain strength until we reach the height of our existence, then humans slowly become less efficient at doing what they do until eventually they cannot sustain themselves any further.

Answer from: Quest

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

Answer from: Quest

a. are

Another question on Physics

Physics, 22.06.2019 05:30

Could someone . i have tried to solve myself but my calculation is off

Answers: 3

Answer

Physics, 22.06.2019 05:30

The volume of a gas is halved during an adiabatic compression that increases the pressure by a factor of 2.5. what is the specific heat ratio? show the math steps .

Answers: 3

Answer

Physics, 22.06.2019 16:30

Acalorimeter uses the principle that thermal energy flows from hotter material to colder material until both reach the same

Answers: 1

Answer

Physics, 22.06.2019 17:00

Two conductors, a and b, are each in the shape of a tetrahedron. but of different sizes. they are charged in the following manner: 1. tetrahedron a is charged from an electrostatic generator to charge q. 2. tetrahedron a is briefly touched to tetrahedron b. 3. steps 1 and 2 are repeated until the charge on tetrahedron b reaches a maximum value. if the charge on tetrahedron b was q/4 after the first time it touched tetrahedron a. what is the final charge qbmax on tetrahedron b?

Answers: 2

Answer

You know the right answer?

Explain why the life cycle of a star can be compared to the life style of a human...

Questions