Physics, 26.03.2021 18:30 fordkt9027

Electricity produced by the wind is the preferred source of electricity as it is cost effective does not produce green house gases, and not creat radioactive waste.

Answers: 2

Show answers

Answers

Answer from: Quest

convex lenses are thicker at the middle. rays of light that pass through the lens are brought closer together (they converge). a convex lens is a converging lens. when parallel rays of light pass through a convex lens the refracted rays converge at one point called the principal focus.

Answer from: Quest

quantum mechanics or quantum physics is physics of very small objects (particles) and physical entities.

quantum physics has some parallels to our macro world and some pretty unique ideas which theoretically and mathematically proven to be true even though we will never be able to access them because of our size.

there are many types of particles: subatomic, elementary etc.

subatomic means they are smaller than atom, elementary means they are at the very basis of everything.

subatomic particles are for eg. protons, neutrons but not electrons.

elementary particles are categorised into 3 groups by what they do.

these 3 groups are quarks, leptons and bosons.

light for example is a particle more precisely a photon a part of leptons.

proton (subatomic particle) is made out of 2 up quarks and 1 down quark each of these has a fractional charge like $\frac{1}{3}$ . (i crazy)

most famous scientist who contributed to this physics are:

max planckalbert einsteinerwin schrödingermany

the topic itself us understand a lot and will probably be vastly used in the future (quantum computers, understanding the big bang,

we also must not forget quantum effects like:

superposition (where 1 thing can be this and that at the same time),entanglement (where two particles are seemingly connected by some sort of unknown (or known) force, energy, matter (i know all that can be the same at least it was at the beginning)

and there is more. but probably too much for this answer to be consistent due to my average understanding of this topic.

hope this you understand quantum mechanics a little more. i'm not an expert in the topic (so don't be like wth if you are an expert) but i'm very interested in it.

anyways quantum physics is a very hard topic (harder than physics (perhaps)) therefore searching for every information there is about it and learning it is unfortunately impossible (you can only specialise into 1 - 3 things or more (perhaps

have fun and i wish you luck!

r3t40

Answer from: Quest

the answer for apex is the lowest

Answer from: Quest

The density of the block of iron is lees than the density of mercury but the density of the block of iron is greater than the density of water

Another question on Physics

Physics, 21.06.2019 22:00

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Answers: 1

Answer

Physics, 22.06.2019 00:20

Consider the particle-in-a-box problem in 1d. a particle with mass m is confined to move freely between two hard walls situated at x = 0 and x = l. the potential energy function is given as (a) describe the boundary conditions that must be satisfied by the wavefunctions ψ(x) (such as energy eigenfunctions). (b) solve the schr¨odinger’s equation and by using the boundary conditions of part (a) find all energy eigenfunctions, ψn(x), and the corresponding energies, en. (c) what are the allowed values of the quantum number n above? how did you decide on that? (d) what is the de broglie wavelength for the ground state? (e) sketch a plot of the lowest 3 levels’ wavefunctions (ψn(x) vs x). don’t forget to mark the positions of the walls on the graphs. (f) in a transition between the energy levels above, which transition produces the longest wavelength λ for the emitted photon? what is the corresponding wavele

Answers: 1

Answer

Physics, 22.06.2019 10:00

Explain the comparisons between nature and packingtown that appears on pages 81 and 82 answer

Answers: 2

Answer

Physics, 22.06.2019 13:20

Arrange the images in order to show how lake-effect snow occurs.

Answers: 2

Answer

You know the right answer?

Electricity produced by the wind is the preferred source of electricity as it is cost effective does...