subject
Physics, 12.12.2020 16:00 aesthetickait

Which vector below represents the direction of the velocity vector when the object in circular motion is located at point B on the circle? (Assume a CW direction of motion)

A) a
B) b
C) c
D) d


Which vector below represents the direction of the velocity vector when the object in circular

mo

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 15:10
Four objects are being tested to see how they are affected by fluid friction. object w has a surface area of 4.5 cm2, object x has a surface area of 2.5 cm2, object y has a surface area of 6.2 cm2, and object z has a surface area of 3 cm2. which object would experience the most fluid friction?
Answers: 3
question
Physics, 22.06.2019 15:50
An object with initial temperature 130 ∘ f is submerged in large tank of water whose temperature is 50 ∘ f . find a formula for f ( t ) , the temperature of the object after t minutes, if the cooling constant is k = − 0.2 . remember newton's law of cooling (the rate of change of temperature with respect to time is equal to k times the difference between the temperature of the object and the surrounding temperature) ! : )
Answers: 1
question
Physics, 22.06.2019 16:40
Beryl states that insulation with the smallest possible thermal conductivity is best to keep a house warm in winter, but worst for keeping a house cool in summer. sapphire insists the reverse is true: low thermal conductivity is good in the summer, but bad in the winter. which one, if either is correct? a. beryl, because low thermal conductivity results in low heat transfer. b. beryl, because low thermal conductivity results in high heat transfer. d. sapphire, because low thermal conductivity results in high heat transfer. e. neither, because low heat transfer is desirable both in summer and in winter.
Answers: 2
question
Physics, 22.06.2019 18:50
8.29 two streams containing pyridine and acetic acid at 25°c are mixed and fed into a heat exchanger. due to the heat-of-mixing effect, it is desired to reduce the temperature after mixing to 25°c using a stream of chilled ethylene glycol as indicated in the diagram. calculate the mass flow rate of ethylene glycol needed. the heat capacity of ethylene glycol at these conditions is approximately 2.8 kj/(kg k), and the enthalpy change of mixing (δmixh) is given below.
Answers: 3
You know the right answer?
Which vector below represents the direction of the velocity vector when the object in circular moti...
Questions
Questions on the website: 13722360