subject
Physics, 17.03.2020 01:00 karlyisaunicorn

Steam enters a one-inlet, two-exit control volume at location (1) at 360°C, 100 bar, with a mass flow rate of 2 kg/s. The inlet pipe is round with a diameter of 5.2 cm. Fifteen percent of the flow leaves through location (2) and the remainder leaves at (3). For steady-state operation, determine the inlet velocity, in m/s, and the mass flow rate at each exit, in kg/s.

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 18:00
Astone is thrown with a speed v0 and returns to earth, as the drawing shows. ignore friction and air resistance, and consider the initial and final locations of the stone. which one of the following correctly describes the change δpe in the gravitational potential energy and the change δke in the kinetic energy of the stone as it moves from its initial to its final location? options a.δpe = 0 j and δke = 0 j b.δpe is positive and δke is negative c.δpe = 0 j and δke is positive d.δpe is negative and δke is positive e.δpe = 0 j and δke is negative
Answers: 3
question
Physics, 22.06.2019 19:30
Water is siphoned from a large tank and discharges into the atmosphere through a 50-mm diameter tube. the end of the tube is b = 2.6 m below the tank bottom which is a = 6.7 m deep, and viscous effects are negligible. determine the maximum height h over which the water can be siphoned without cavitation occurring. atmospheric pressure is 101.4 kpa, and the water vapor pressure is 1.79 kpa (absolute). report your answer in meters to two decimal places.
Answers: 1
question
Physics, 22.06.2019 21:10
Two masses are connected by a rope that hangs over a pulley as shown below. the pulley is a uniform cylinder of radius 푅=0.381meters and mass 푀=3.1푘푔. initially 푚"is on the ground and 푚#rests 2.5 meters above the ground. if the system is released, use conservation of energy to determine the speed of 푚#just before it strikes the ground. assume the pulley bearing is frictionless.
Answers: 2
question
Physics, 22.06.2019 21:40
Wo small variable-thrust jets are actuated to keep the spacecraft angular velocity about the z-axis constant at ? 0 = 1.16 rad/s as the two telescoping booms are extended from r1 = 1.18 m to r2 = 4.69 m at a constant rate over a period of 124 seconds. the small 19-kg experiment modules at the ends of the booms may be treated as particles, and the mass of the rigid booms is negligible. determine the necessary thrust t for each jet as a function of time where t = 0 is the time when the telescoping action is begun. after you have the general expression for t, answer the questions. show work.
Answers: 1
You know the right answer?
Steam enters a one-inlet, two-exit control volume at location (1) at 360°C, 100 bar, with a mass flo...
Questions
question
Mathematics, 15.11.2019 18:31
question
Mathematics, 15.11.2019 18:31
question
Mathematics, 15.11.2019 18:31
question
English, 15.11.2019 18:31
Questions on the website: 13722363