subject
Physics, 18.02.2020 18:01 rebecca0022

Room temperature water is placed in an Erlenmyer flask and heated to the boiling point. After the flask is removed from the heat source boiling ceases. Then a rubber stopper is placed in the mouth of the Erlenmyer flask to seal it from outside air. The flask is then placed in an ice bath. After a few moments the water begins to boil again. What phenomenon causes the water to boil again?

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
question
Physics, 22.06.2019 09:50
Gordon is going for a run through the park, but it is cold outside. the low outside temperature could affect his personal safety.
Answers: 1
question
Physics, 22.06.2019 11:50
Amoving electron has kinetic energy k1. after a net amount of work w has been done on it, the electron is moving one-quarter as fast in the opposite direction. (a) find w in terms of k1. (b) does your answer depend on the final direction of the electron's motion?
Answers: 2
question
Physics, 22.06.2019 17:00
(a) if the pressure in gas is doubled while its volume is held constant, by what factor do (i) vrms and (ii) change? (b) is it possible to boil water at room temperature (20oc) without heating it? explain.
Answers: 3
You know the right answer?
Room temperature water is placed in an Erlenmyer flask and heated to the boiling point. After the fl...
Questions
question
Mathematics, 14.12.2020 14:00
question
Health, 14.12.2020 14:00
question
Biology, 14.12.2020 14:00
question
Mathematics, 14.12.2020 14:00
question
Physics, 14.12.2020 14:00
Questions on the website: 13722367