subject

English, 06.11.2019 22:31 isabelj2004

If the guide words on a dictionary page were errand and expect what words will not be on the page

If the guide words on a dictionary page were errand and expect what words will not be on the page

ansver

Answers: 3

Show answers

Another question on English

question

English, 21.06.2019 14:40

Based on the author’s description of long island, the reader can infer that this novel willrelate events about unconventional individuals.relate events that occur directly within the city of new york.relate events that are supernatural and terrifying in nature.relate events having to do with highly privileged individuals.

Answers: 2

question

English, 21.06.2019 17:00

Synonyms and antonyms of the word mean is

Answers: 2

question

English, 22.06.2019 00:30

What is the definition of scathing? a. to assail with abusive language c. to deter by advice or persuasion b. bitterly severe, as a remark d. the west wind; a mild wind

Answers: 2

question

English, 22.06.2019 01:30

Read the passage. and thus they fought all the long day, and never stinted till the noble knights were laid to the cold earth. and ever they fought still till it was near night, and by then was there a hundred thousand laid dead upon the down. in the passage from morte d’arthur by sir thomas malory, what are the bolded words an example of?

Answers: 1

You know the right answer?

If the guide words on a dictionary page were errand and expect what words will not be on the page

Questions

question

Engineering, 14.09.2019 02:10

Apolyimide photoresist requires 90 mj/cm^2 per micron of thickness to be developed properly. if a lamp provides 900 w/m, how long does it take to expo...

question

Engineering, 14.09.2019 02:10

Determine ixx for the cylinder with a concentarted circular hole. the mass of body is m...

question

Engineering, 14.09.2019 02:10

Two 14.5° pressure angle, mating, 5-pitch gears have 30 and 110 teeth. in practice, the gears are mounted at a center distance 0.7 inches greater than...

question

Engineering, 14.09.2019 02:10

The center distance of two spur gears that have 20° pressure angle and full-depth with diametral pitch of 8 teeth/in, is increased by 0.05 in over the...

question

Engineering, 14.09.2019 02:10

Two meshing 24-pitch, 25° pressure angle gears have n1-24 and n2 60 teeth. the in use center distance of the two gears is 0.16 inches larger than the...

question

Engineering, 14.09.2019 02:10

Batteries are used in a plc's processor to a. maintain data in nonvolatile memory when line power is removed from the processor. b. maintain data in v...

question

Engineering, 14.09.2019 02:10

Acomplex cmos fabrication process requires 25 masks a. what fraction of the dice must be good (i. e. what yield must be obtained) during each mask ste...

question

Engineering, 14.09.2019 02:10

Draw and label a typical true stress-strain curve for a ductile material....

question

Engineering, 14.09.2019 02:10

Draw and label a typical engineering stress-strain curve for a brittle material....

question

Engineering, 14.09.2019 02:10

Determine the length l of each of the slender rods of mass m/2 which must be centrally attached to the faces of the thin homogeneous disk of mass m in...

question

Engineering, 14.09.2019 02:10

Afour-stroke cycle engine delivers a torque of 437 ft-lb at the flywheel (output shaft) when the engine speed is 2100 rpm while using 514 hp of fuel e...

question

Engineering, 14.09.2019 02:10

It takes a man 12.5 hours to complete a 500-mile trip in his automobile, during which 18 gallons of gasoline are consumed. during this trip, the avera...

question

Engineering, 14.09.2019 02:10

For a motor purchased for a tank project, it claims that at 12v it produces 6000 rpm. this motor is attached to a 50: 1 gear reduction gearbox. the ou...

question

Engineering, 14.09.2019 02:10

Which of the two materials (brittle vs. ductile) usually obtains the largest modulus of toughness and why?...

question

Engineering, 14.09.2019 02:10

Afour-cylinder chrysler si engine has the following characteristics: 2.2l displacement, 87.5 mm bore, 92 mm stroke, 8.9 compression ratio, and a maxi...

question

Physics, 14.09.2019 02:10

Abead with a mass of 0.050 g and a charge of 20 nc is free to slide on a vertical rod. at the base of the rod is a fixed 20 nc charge. in equilibrium,...

question

Engineering, 14.09.2019 02:10

Which of the two materials (brittle vs. ductile) usually obtains the highest ultimate strength and why?...

question

Physics, 14.09.2019 02:10

Asmall bead with a positive charge q is free to slide on a horizontal wire of length 4.5 cm . at the left end of the wire is a fixed charge q, and at...

question

Physics, 14.09.2019 02:10

A1500kg space probe is moving at constant velocity of 4200m/sec. in a course change maneuver the rocket engines fire for 5 minutes increasing the prob...

question

Physics, 14.09.2019 02:10

Aconvex lens of focal length 35 cm produces a magnified image 2.5 times the size of the object. what is the object distance if the image (formed) is r...

More questions: English Another questions

Questions on the website: 13722363