∘
C
Engineering, 29.11.2021 14:40 unknown1246
Superheated steam enters an insulated turbine shown below at 4,000 kPa and
500
∘
C
and leaves as saturated vapor at 20 kPa. If the mass flux is 6 kg/sec, determine the maximum power output and the exiting velocity. Neglect the changes in KE and PE between the inlet and outlet.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
Superheated steam enters an insulated turbine shown below at 4,000 kPa and
500
∘
C
∘
C
Questions
History, 22.05.2020 05:04
Mathematics, 22.05.2020 05:04
English, 22.05.2020 05:04
Chemistry, 22.05.2020 05:04
Mathematics, 22.05.2020 05:04
Mathematics, 22.05.2020 05:04
