Engineering, 03.06.2021 16:20 tyryceschnitker

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C, and 80 m/s, and the exit conditions are 92 percent quality, and 50 m/s. The mass flow rate of the steam is 12 kg/s. Investigate the effect of the turbine exit pressure on the power output of the turbine. Let the exit pressure vary from 10 to 200 kPa (10 different pressure namely 10, 30, 40, 50, 75, 100, 125, 150, 175, 200 kpa is enough). Prepare a table and two plot as follows:
• Tabulate turbine exit pressure, the power output of the turbine and turbine exit temperature (the table template is below)
• Plot the power output against the exit pressure,
• Plot the exit temperature against the exit pressure,
• and discuss the results

Not: The red ones my answers but I'm not really sure about them.

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

You know the right answer?

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C...

Questions