Engineering, 27.04.2021 14:40 cleef6451

11.D1 The following is a list of metals and alloys: Plain carbon steel Magnesium Brass Zinc Gray cast iron Tool steel Platinum Aluminum Stainless steel Tungsten Titanium alloy Select from this list the one metal or alloy that is best suited for each of the following applications, and cite at least one reason for your choice: (a) The block of an internal combustion engine (b) Condensing heat exchanger for steam (c) Jet engine turbofan blades (d) Drill bit (e) Cryogenic (i. e., very low temperature) container (f) As a pyrotechnic (i. e., in flares and fireworks) (g) High-temperature furnace elements to be used in oxidizing atmospheres

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

11.D1 The following is a list of metals and alloys: Plain carbon steel Magnesium Brass Zinc Gray cas...

Questions

SAT, 31.01.2020 01:57

Which types of weathering and erosion are primarily responsible for the formation of caves?...