subject
Engineering, 23.04.2021 15:40 haileysolis5

An arrival rate of 720 veh/h arrive at a single lane signalized approach that is controlled by a traffic signal that operates at a cycle length of 60 seconds and a 50:50 green split. The amber and all-red interval is 5 seconds. The unopposed saturation flow rate was measured to be 1800 veh/h/lane with a start-loss 2 seconds and end gain of 3 seconds, respectively. For the approach do the following for a single cycle length: a. Compute the maximum queue size formed upstream the traffic signal.
b. Compute the time required to dissipate the queue.
c. Compute the average vehicle delay experienced by vehicles traveling on the approach using the macroscopic procedures that were described in the class.
d. Compute the average vehicle delay experienced by vehicles traveling on the approach by tracking the arrival and departure times of each vehicle. Assume the first vehicle arrives at the midheadway after the red interval starts.
e. Repeat part (d) considering the first vehicle arrival ranges from 0 to 5 seconds. Comment on the sensitivity of delay estimates to the arrival time of the first vehicle.
f. Compute the number of vehicles that come to a complete stop during the cycle length.
g. Compute the maximum delay experienced by a vehicle.
h. What is the delay experienced by the third vehicle in queue assuming that the first vehicle arrives at the start of the red.
The Cycle length is 60 seconds. The problem should be solved fo a single cycle length.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40Β°c and pl = 1 .2 mpa. water vapor att2-200Β°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
You know the right answer?
An arrival rate of 720 veh/h arrive at a single lane signalized approach that is controlled by a tra...
Questions
question
Mathematics, 25.02.2021 21:50
question
Chemistry, 25.02.2021 21:50
question
Mathematics, 25.02.2021 21:50
question
Mathematics, 25.02.2021 21:50
question
Mathematics, 25.02.2021 21:50
question
Health, 25.02.2021 21:50
Questions on the website: 13722359