Engineering, 18.03.2021 01:00 lovecats12
If increased productivity in the workplace is an example of the macroeconomic impact of the green economy and increased income from new jobs is an example of its microeconomic impact, then what does this imply about the difference between macroeconomic and microeconomic factors when measuring the green economy’s impact? (Select all that apply.)
The green economy’s macroeconomic effects are best seen in broad patterns, and its microeconomic effects in specific events.
The green economy’s macroeconomic effects are best seen from the top down, and its microeconomic effects from the bottom up.
The green economy’s macroeconomic effects are more speculative, and its microeconomic effects are measurable and concrete.
The green economy’s macroeconomic effects are most telling for measuring its true impact, and its microeconomic effects are too short term to be reliable indicators of impact.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
If increased productivity in the workplace is an example of the macroeconomic impact of the green ec...
Questions
Biology, 15.04.2020 00:51
Computers and Technology, 15.04.2020 00:51
