subject
Engineering, 14.02.2021 03:30 7obadiah

Project: Construction and Demolition Materials in Single-Family Homes: Analyze an EPA Report Assignment directions

In this project you will consider what to do with the C&D materials after a house is demolished. Read the EPA report “Analysis of the Life Cycle Impacts and Potential for Avoided Impacts Associated with Single-Family Homes” at epa. gov and answer the questions below.

Assignment guidelines

Part 1: Write a short introduction that defines life-cycle assessment, its phases, and what C&D materials are. Label it “Introduction.”

Part 2: Answers the following questions in complete paragraphs. Label this section “Analysis.” Number your answers 1 through 4:

1. What are some of the health and safety considerations for recycled or reused materials?
2. Do you think adherence to Life Cycle Assessment is good for the construction industry? Why or why not?
3. How is demolishing a house like building a house?
4. Which process appeals to you more: Building a house or demolishing a house? Explain your opinions.
Feel free to consult other resources for more information or to help you form an opinion. If you do, please list them in a Reference section with URLs if applicable.

Submission requirements

Submit your paper electronically. It should be 2 to 3 pages long. Sentences should be complete. Define your terms. Spelling, punctuation, and grammar count.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:10
Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.
Answers: 2
question
Engineering, 06.07.2019 04:20
Explain the similarities and differences in the design guidelines for turning and for
Answers: 1
You know the right answer?
Project: Construction and Demolition Materials in Single-Family Homes: Analyze an EPA Report Assign...
Questions
question
Mathematics, 17.11.2020 01:00
question
Mathematics, 17.11.2020 01:00
question
Mathematics, 17.11.2020 01:00
question
Mathematics, 17.11.2020 01:00
Questions on the website: 13722367