subject
Engineering, 31.01.2021 21:00 msbanks317

Can someone please do this for me ive been sick for the past week and am behind Identify the engineering innovation that you have chosen to investigate. State the inventor of the new technology, the year of the initial invention, and the problem that the technology was created to solve.
Describe what other technologies were available at the time that may have influenced your inventor.
Discuss tests done on the design and any modifications that were made to the original design. These modifications may have been made by the original inventor or by subsequent engineers.
Give your opinion as to whether the technology was a success or failure. Address whether or not the innovation solved the original problem.
Discuss the importance of your chosen technology in your current life.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 06.07.2019 04:30
Calculate the resolved shear stress on the (111)[011] slip system of a unit cell in an fcc nickel single crystal if a stress of 13.7 mpa is applied in the [001] direction of a unit cell.
Answers: 1
question
Engineering, 06.07.2019 05:10
The ivanpah solar thermal power plant cost $2.2 billion to build. the gross plant electric output is 392 mw, and the net output is 377 mw. the planned capacity factor was 27.4%, but the actual capacity factor in 2016 was 20.5%. at best the plant thermal efficiency appears to be 18%. in addition, for the daily startup process, the solar plant also burned 1.3x10^12 btu of natural gas in 2016. the cost of natural gas in 2016 was about $2.5 per million btu. assuming a levelized annual fixed charge rate of 7%, determine (a) the capital cost (c/kwh) and (b) the fuel cost (e/k wh) for the electricity in 2016.
Answers: 3
You know the right answer?
Can someone please do this for me ive been sick for the past week and am behind Identify the engine...
Questions
question
Mathematics, 18.02.2021 01:00
question
Physics, 18.02.2021 01:00
question
Mathematics, 18.02.2021 01:00
question
SAT, 18.02.2021 01:00
question
Arts, 18.02.2021 01:00
Questions on the website: 13722367