Engineering, 18.01.2021 14:00 madmatt873

Suppose your bathroom sink is clogged and you have decided to try and unclog it by pushing a wire into the drain. You have several types of wire available around the house, some insulated and some not. Which of the following wire characteristics would you need to consider in selecting a wire for the job? The wire characteristics are listed as follows:

a. Immunity to electrical noise
b. Color of the insulation
c. Resistance of the insulation to salt water
d. Resistance of the insulation to fire
e. Cost
f. Stiffness
g. Ease of stripping the insulation -
h. Weight
i. Availability
j. Strength
k. Resistance to high temperatures
l. Resistance to stretching

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

Suppose your bathroom sink is clogged and you have decided to try and unclog it by pushing a wire in...

Questions