Engineering, 19.11.2020 22:50 treaustin6978
Calculate the power transmitted through a 50 mm diameter solid steel shaft that is 2 m in length. The allowable shear stress on the shaft is 80 MPa, and the allowable angle of twist is 0.050 radians. The shaft is turning at 500 rpm, and has a shear modulus, G = 85,000 MPa.
Answers: 1
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Calculate the power transmitted through a 50 mm diameter solid steel shaft that is 2 m in length. Th...
Arts, 27.11.2020 22:20
Mathematics, 27.11.2020 22:20
Health, 27.11.2020 22:20
Computers and Technology, 27.11.2020 22:20
Mathematics, 27.11.2020 22:20
English, 27.11.2020 22:20