Engineering, 24.04.2020 19:35 Geo777

5. You have been asked to develop a system to mix and bottle orange juice from concentrate. (5 points) Hint: you will need to select a PLC with more than 4 outputs to simulate this system. a. Low level detectors in the water (I1) and concentrate (I2) tanks prevent operating the water (Q1) and concentrate (Q2) pumps. b. The orange juice tank has a high level detector (I4) which stops the pumps in the water and concentrate tanks. c. The conveyor belt motor (Q4) is initiated by a start (I6) and stop (I7) button. d. When a bottle is detected under the spigot (I5), the conveyor belt is stopped e. The orange juice pump (Q3) is operated for 10 seconds to fill the bottle. f. The conveyor belt is then restarted. g. The red indicator light (Q5) is illuminated if the orange juice tank has a low level h. The green indicator light (Q6) is indicated during normal operation.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Explain the strain-hardening phenomenon on the basis of dislocation - dislocation strain field interactions. also, briefly describe what generally happens to the ductility of a metal that has been strain hardened (i.e. does strain hardening make a metal more ductile or

Answers: 3

Answer

Engineering, 06.07.2019 04:20

Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.

Answers: 1

Answer

You know the right answer?

5. You have been asked to develop a system to mix and bottle orange juice from concentrate. (5 point...

Questions