Engineering, 05.03.2020 14:26 rleiphart1

A stainless-steel billet (6 in. diameter, 1 ft long) is passing through a 20-ft-long heat-treating furnace. The initial billet temperature is 200°F, and it must be raised to a minimum temperature of 1500°F before working. The heat-transfer coefficient between the furnace gases and the billet surface is 15 Btu/h ft2 °F, and the furnace gases are at 2300 °F. (a) (3 pts) Draw a schematic of the problem. (b) (2 pts) State assumptions if you need to make any (c) (20 pts) At what minimum velocity must the billet travel through the furnace to satisfy these conditions?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

A stainless-steel billet (6 in. diameter, 1 ft long) is passing through a 20-ft-long heat-treating f...

Questions