Engineering, 28.02.2020 00:38 mikehager4321

Circular copper rods of diameter D=1mm and length L=25mm areused to enhance heat transfer from a surface that is maintained atTs,1=100 deg. C. One end of the rod is attached tothis surface (at x=o), hile the other end (at x=25mm) is joined toa second surface that is maintained at Ts,2=0deg. C. Air flowing between the surfaces (and over the rods)is also at a temperature T?= 0 deg. C, and has a convectioncoefficient of h=100 w/m2kelvin.

a. What is the rate of heat transfer by convection from a singlecopper rod to air?
b. What is the total rate of heat transfer from a 1 m x 1 m section of the surface at 100 deg. C, if a bundle of the rods is installed on 4-mm centers?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Circular copper rods of diameter D=1mm and length L=25mm areused to enhance heat transfer from a sur...

Questions