subject
Engineering, 26.02.2020 03:58 musicalmel

Consider an ideal turbojet with an afterburner operating at flight Mach number of 2.0 at an altitude where the ambient static temperature: Ta = −70 ◦C and static pressure: pa = 15 kPa. The compressor pressure ratio is 10, the maximum temperature at the entrance to the nozzle is 2250 ◦K while the turbine outlet temperature is 700 ◦K. We assume that the exit Mach number Megxit = Mf light with the flow expanding in the nozzle to the ambient conditions at the exit. If the total fuel-to-air ratio for = 0.0519 for a fuel heating value of 45,000 kJ/kg, then determine:

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
Consider an ideal turbojet with an afterburner operating at flight Mach number of 2.0 at an altitude...
Questions
Questions on the website: 13722360