subject
Engineering, 05.12.2019 21:31 estherdinhllama

The popularity of orange juice, especially as a breakfast drink, makes this beverage an important factor in the economy of orange-growing regions. most marketed juice is concentrated and frozen and then reconstituted before consumption, and some is "not-from-concentrate." although concentrated juices are less popular in the united states than they were at one time, they still have a major segment of the market for orange juice. the approaches to concentrating orange juice include evaporation, freeze concentration, and reverse osmosis. here we examine the evaporation process by focusing only on two constituents in the juice solids and water. fresh orange juice contains approximately 10 wt% solids (sugar, citric acid, and other ingredients) and frozen concentrate contains approximately 42 wt% solids. the frozen concentrate is obtained by evaporating water from the fresh juice to produce a mixture that is approximately 65 wt% solids. however, so that the flavor of the concentrate will closely approximate that of fresh juice, the concentrate from the evaporator is blended with fresh orange juice (and other additives) to produce a final concentrate that is approximately 42 wt% solids. (a) label the flowchart of this process, neglecting the vaporization of everything in the juice but water first prove that the subsystem containing the point where the bypass stream splits off from the evaporator feed has one degree of freedom. (if you think it has zero degrees, try determining the unknown variables associated with this system.) then perform the degree-of freedom analysis for the overall system, the evaporator, and the bypass-evaporator product mixing point, and write in order the equations you would solve to determine all unknown stream variables. in each equation, circle the variable for which you would solve, but don't do any calculations. (b) calculate the amount of product (42% concentrate) produced per 100 kg fresh juice fed to the process and the fraction of the feed that bypasses the evaporator. bypass mising point evaporator

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
question
Engineering, 06.07.2019 03:20
Steam at a pressure of 100 kpa and a quality of 50% initially fills a rigid vessel having a volume of 0.5 m^3. the steam is then heated, causing the pressure in the vessel to rise to 150 kpa. determine: i. the mass of the steam in the vessel. ii. the temperature and quality of the steam after the heating process. ii the mass of the vapour, mg and liquid, m in the vessel after the heating process. if the steam in the vessel is now further heated, what would the pressure and temperature in the vessel be when all steam has turned into saturated vapour? b. sketch the processes in part (a) and part (b) on p-v and t-v diagrams, indicating clearly the temperatures, pressures and the paths. c. (0.59kg, 111.4°c, 73%, 0.4307kg, 0.1 593kg, 2.11 bar, 121.84°c)
Answers: 1
You know the right answer?
The popularity of orange juice, especially as a breakfast drink, makes this beverage an important fa...
Questions
question
Mathematics, 01.02.2020 22:42
question
Social Studies, 01.02.2020 22:42
question
Mathematics, 01.02.2020 22:42
Questions on the website: 13722361