Engineering, 20.02.2020 04:56 zahraa244
Both portions of the rod ABC are made of an aluminum for which E = 70 GPa. Given: P = 4.5 kN. Problem 02.019.a - Deformations in a stepped shaft loaded in tension and compression Determine the value of Q so that the deformation at A is zero.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Both portions of the rod ABC are made of an aluminum for which E = 70 GPa. Given: P = 4.5 kN. Proble...
Questions
History, 21.01.2021 23:10
Mathematics, 21.01.2021 23:10
Mathematics, 21.01.2021 23:10
English, 21.01.2021 23:10
Mathematics, 21.01.2021 23:10
