Engineering, 24.01.2020 02:31 sushiboy668
Assign match found with true if the difference between firstsample and secondsample is within thresholdvalue function matchfound = ismatch(first sample, secondsample, thresholdvalue) % firstsample: sample value % secondsample: sample value % thresholdvaiue: maximum difference between samples so that sample are considered equal %assign matchfound with true if the difference between firstsample and secondsample % are within thresholdvalue matchfound = 0; end code to call your function when you click run ismatch((4/5), 0.8, 0.0001)
Answers: 3
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Assign match found with true if the difference between firstsample and secondsample is within thresh...
Social Studies, 19.10.2019 12:50
Biology, 19.10.2019 12:50
History, 19.10.2019 12:50
Physics, 19.10.2019 12:50
Mathematics, 19.10.2019 12:50
Biology, 19.10.2019 12:50
Mathematics, 19.10.2019 12:50
Chemistry, 19.10.2019 12:50
Mathematics, 19.10.2019 12:50
Chemistry, 19.10.2019 13:00