subject
Engineering, 26.12.2019 22:31 jzoda7318

Consider the following bcnf schema and a portion of a simple corporate database (type
information is not relevant to this question and is omitted):
emp(eid, ename, addr, sal, age, yrs, deptid)
dept(did, dname, floor, budget)
suppose you know that the following queries are the six most common queries in the workload
for this corporation and that all six are roughly equivalent in frequency and importance:
 list the id, name and address of employees in a user-specified age range
 list the id, name and address of employees who work in the department with a userspecified department name
 list the id and address of employees with a user- specified employee name
 list the overall average salary for employees
 list the average salary for employees of each age; that is, for each age in the database,
list the age and the corresponding average salary.
 list all the department information, ordered by department floor numbers.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
You know the right answer?
Consider the following bcnf schema and a portion of a simple corporate database (type
informat...
Questions
Questions on the website: 13722367