subject
Engineering, 18.12.2019 01:31 noeliaalvarado

Acommunication system uses a sec-ded (single error correction-double error detection) code to protect transmissions. the code is based on a 7-bit hamming code extended with an odd parity bit (the most significant bit x8). using the notation from the notes, each received word consists of the parity bit followed by the 7-bit hamming code word x7x6x5x4x3x2x1. for each of the following received words, extract the 4-bit data word when possible, or mention that the received word had uncorrectable errors.
hint: remember that this code is able to correct single errors. if you detect an error and can flip 1 bit to get to a valid codeword, then you have found and fixed the error. if you can't get to a valid codeword with 1 bit flip, then the received word is uncorrectable because there may be more than one way to flip two bits to get to valid codewords.

00101101
1000
10101001
10010001
00111001

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
Acommunication system uses a sec-ded (single error correction-double error detection) code to protec...
Questions
question
Mathematics, 28.01.2020 05:31
question
Mathematics, 28.01.2020 05:31
Questions on the website: 13722359