Engineering, 28.11.2019 01:31 katey6934

To augment heat transfer between two flowing fluids, it is proposed to insert a 100-mm- long, 5-mm-diameter 2024 aluminum pin fin through the wall separating the two fluids, as seen in fig.1. the pin is inserted to a depth of d into fluid 1. fluid 1 is air with a mean temperature of 10°c and nearly uniform velocity of 10 m/s. fluid 2 is air with a mean temperature of 40°c and mean velocity of 3 m/s.

a) determine the rate of heat transfer from the warm air to the cool air through the pin fin for d=50 mm

b) plot the variation of the heat transfer rate with the insertion distance,

d. does an optimal insertion distance exist? t = 10°c, v = 10 m/s d-5 mm l = 100 mm 7.-40°c, v = 3 m/s

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

To augment heat transfer between two flowing fluids, it is proposed to insert a 100-mm- long, 5-mm-d...

Questions