subject
Engineering, 28.11.2019 01:31 gutierrezaandrea56

Two containers, x and y, both contain nitrogen gas at a temperature of 30° c and a pressure of 1 atm. the initial volume of each of the containers is v30 = 0.5 liters. the only difference between the two containers is that while container x has a piston that is sealed and cannot move, the gas in container y is allowed to expand against the surrounding atmosphere. qx is the amount of heat required to raise the temperature of the gas in container x by 10° c, and qy is the amount of heat required to raise the temperature of the gas in container y by 10° c. what is the difference between qx and qy? use 0°c = 273.15 k qx - qy =

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
question
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
Two containers, x and y, both contain nitrogen gas at a temperature of 30° c and a pressure of 1 atm...
Questions
question
Mathematics, 18.02.2022 18:20
Questions on the website: 13722367