Engineering, 22.11.2019 06:31 Hfruit

Glycerin is being heated by flowing between two very thin parallel 1-m-wide and 10-m-long plates with 12.5-mm spacing. the glycerin enters the parallel plates with a temperature 20°c and a mass flow rate of 0.7 kg/s . the outer surface of the parallel plates is subjected to hydrogen gas (an ideal gas at 1 atm) flow width-wise in parallel over the upper and lower surfaces of the two plates. the free-stream hydrogen gas has a velocity of 3 m/s and a temperature of 150°c. determine the outlet mean temperature of the glycerin, the surface temperature of the parallel plates, and the total rate of heat transfer. evaluate the properties for glycerin at 30°c and the properties of h2 gas at 100°c. are these good assumptions?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

Engineering, 06.07.2019 03:30

The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.

Answers: 2

Answer

Engineering, 07.07.2019 02:20

When the piston is at its highest position in the cylinder, it’s said to be at the is a hollow metal tube drilled into the metal engine block. the top of the cylinder is sealed by a metal cover called the in a gasoline-powered engine, the ignites the air-and-fuel mixture in the cylinder and causes it to burn. why is it critical for the upper and lower end sections of an engine to work perfectly together?

Answers: 1

Answer

You know the right answer?

Glycerin is being heated by flowing between two very thin parallel 1-m-wide and 10-m-long plates wit...

Questions