Engineering, 19.11.2019 02:31 Eddie997

The components of an electronic system dissipating 180 w are located in a 1-m-long horizontal duct whose
cross section is 16cm x 16 cm. the components in the duct are cooled by forced air, which enters at 27oc at a
rate of 0.65 m3/min. assuming 85 percent of the heat generated inside is transferred to air flowing through
the duct and the remaining 15 percent is lost through the outer surfaces of the duct, determine
(a) the exit temperature of air and
(b) the highest component surface temperature in the duct. (note: for the purpose of
determining the air properties, you can assume the mean bulk temperature of air is 35oc).

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

The components of an electronic system dissipating 180 w are located in a 1-m-long horizontal duct w...

Questions