To make a proper glue joint, you must . 10 points
a. have the surfaces rough to make the glue sink in and stick better.
b. have the surfaces wet or at least damp to help the glue sink into the surfaces.
c. have the surfaces of the wood a bit wavy to allow for pockets of glue to form.
d. have the surfaces clean and smooth for a good fit up.

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.