Program ex2; int n; int m; // global procedure p1(int x, int y, int z) begin x : = 1; z : = x + y; end; begin n : = 2; m : = 0 p1 (n, n, m) print (m); end. a) what is printed for m if parameters passed by reference? b) what is printed for m if parameters passed by value-results?

How should you set the ohms adjust control on a multitester of analog vom, for resistance measurements?

Assume that there is a 4% rate of disk drive failure in a year. a. if all your computer data is stored on a hard disk drive with a copy stored on a second hard disk drive, what is the probability that during a year, you can avoid catastrophe with at least one working drive? b. if copies of all your computer data are stored on three independent hard disk drives, what is the probability that during a year, you can avoid catastrophe with at least one working drive?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.