Chemistry, 27.03.2020 03:54 Seaisnowblue

1. Calculate the average volume of Na2S2O3 needed for the titration of 25.00 mL of diluted bleach. 2. Use the average volume and molarity of Na2S2O3 to determine the molarity of the diluted bleach (hint: use the equations in the introduction). 3. Calculate the molarity of the commercial bleach. 4. Assume that the density of the commercial bleach is 1.08 g/mL. Calculate the percent by mass of NaCl in the commercial bleach. 5. Calculate the percent error of your value.

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 21.06.2019 22:30

Hot air balloons float in the air because of the difference in density between cold and hot air. in this problem, you will estimate the minimum temperature the gas inside the balloon needs to be, for it to take off. to do this, use the following variables and make these assumptions: the combined weight of the pilot basket together with that of the balloon fabric and other equipment is w. the volume of the hot air inside the balloon when it is inflated is v. the absolute temperature of the hot air at the bottom of the balloon is th (where th> tc). the absolute temperature of the cold air outside the balloon is tc and its density is ďc. the balloon is open at the bottom, so that the pressure inside and outside the balloon is the same. as always, treat air as an ideal gas. use g for the magnitude of the acceleration due to gravity.

Answers: 1

Answer

Chemistry, 22.06.2019 00:40

Base your answer on the information below and on your knowledge of chemistry. nitrogen dioxide, no2, is a dark brown gas that is used to make nitric acid and to bleach flour. nitrogen dioxide has a boiling point of 294 k at 101.3 kpa. in a rigid cylinder with a movable piston, nitrogen dioxide can be in equilibrium with colorless dinitrogen tetroxide, n2o4. this equilibrium is represented by the equation below. 2no2(g) n2o4(g) + 58kj at standard pressure, compare the strength of intermolecular forces in no2(g) to the strength of intermolecular forces in n2(g).

Answers: 2

Answer

Chemistry, 22.06.2019 09:00

Chemical energy is a form of a. kinetic energy only. b. both potential and kinetic energy. c. neither potential nor kinetic energy. d. potential energy only. reset

Answers: 1

Answer

Chemistry, 22.06.2019 10:50

How many liters of oxygen gas, at standard temperature and pressure, will react with 35.8 grams of iron metal? 4 fe (s) + 3 o₂ (g) → 2 fe₂o₃ (s)

Answers: 2

Answer

You know the right answer?

1. Calculate the average volume of Na2S2O3 needed for the titration of 25.00 mL of diluted bleach. 2...

Questions