subject
Physics, 24.07.2019 12:00 taykola

What would the current be for this circuit if there were five volts of electric potential, and the following resistances: r1=4.0, r2=3.2, and r3=3.4?

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 17:00
How can waves travel through ground?
Answers: 1
question
Physics, 22.06.2019 19:30
A1.5m wire carries a 2 a current when a potential difference of 52 v is applied. what is the resistance of the wire?
Answers: 1
question
Physics, 22.06.2019 23:40
To place a communications satellite into a geosynchronous orbit at an altitude of 22,240 mi above the surface of the earth, the satellite first is released from a space shuttle , which is in a circular orbit at an altitude of 185 mi, and then is propelled by an upper-stage booster to its final altitude. as the satellite passes through a, the booster's motor is fired to insert the satellite into an elliptic transfer orbit. the booster is again fired at b to insert the satellite into a geosynchronous orbit. knowing that the second firing increases the speed of the satellite by 4810ft/s, determine (a.) the speed of the satellite as it approaches b on the elliptic transfer orbit, (b.) the increase in speed resulting from the first firing at a.
Answers: 2
You know the right answer?
What would the current be for this circuit if there were five volts of electric potential, and the f...
Questions
question
Mathematics, 02.05.2021 05:10
question
Mathematics, 02.05.2021 05:10
question
Mathematics, 02.05.2021 05:10
question
Mathematics, 02.05.2021 05:10
Questions on the website: 13722367