Physics, 24.07.2019 23:00 calebwoodall6477

What three basic components are atoms made of?

Answers: 1

Show answers

Answers

The three main parts of an atom are protons, neutrons, and electrons. Protons - have a positive charge, located in the nucleus, Protons and neutrons have nearly the same mass while electrons are much less massive. Neutrons- Have a negative charge, located in the nucleus

Answer from: Quest

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

Answer from: Quest

a solenoid is created by wrapping a l = 90 m long wire around a hollow tube of diameter d = 4.5 cm. the wire diameter is d = 0.9 mm. the solenoid wire is then connected to a power supply so that a current of i = 9 a flows through the wire.

randomized variablesl = 90 m

d = 4.5 cm

d = 0.9 mm

i = 9 a

write an expression for the number of turns, n, in the solenoid. you do not need to take into account the diameter of the wire in this calculation.

calculate the number of turns, n, in the solenoid.

write an expression for the length of the solenoid (l2) in terms of the diameter of the hollow tube d.

calculate the length of the solenoid (l2) in meters.

calculate the magnitude of the magnetic field at the center of the solenoid in teslas.

explanation:

Another question on Physics

Physics, 21.06.2019 18:00

Aproton is projected toward a fixed nucleus of charge +ze with velocity vo. initially the two particles are very far apart. when the proton is a distance r from the nucleus its velocity has decreased to 1/2vo. how far from the nucleus will the proton be when its velocity has dropped to 1/4vo?

Answers: 3

Answer

Physics, 21.06.2019 22:50

Acar of mass m goes around a banked curve of radius r with speed v. if the road is frictionless due to ice, the car can still negotiate the curve if the horizontal component of the normal force on the car from the road is equal in magnitude to 101) a) mv2/r b) mg/2. d) mg e) tan[v2/(eg)]

Answers: 2

Answer

Physics, 22.06.2019 02:30

Aforce of 9.00 newtons acts at an angle of 19.0 to the horizontal. what is its component in the horizontal direction?

Answers: 2

Answer

Physics, 22.06.2019 10:30

Apulley with mass mp and a radius rp is attached to the ceiling, in a gravity field of 9.81 m/s2 and rotates with no friction about its pivot.