subject
Physics, 04.08.2019 00:00 KpopSushi

As mentioned in this week’s notes on page 4, the electrons of an atom can occupy different energy shells within the atom (similar to how the planets all occupy different orbits around the sun). electrons prefer to be in the lowest energy shell possible (the ground state); however, they can gain energy and jump to a higher shell by absorbing light or being excited by an electric current. in accordance with the conservation of energy, if an electron drops from a higher energy level to a lower one, this must emit a photon (particle of light) with energy equal to the energy difference of the shells. a balmer series transition is any transition of an electron from some higher energy shell down to the second lowest energy shell (n=2) in hydrogen. looking at image (b) above, what is the wavelength of a photon emitted during the balmer transition from the n=3 shell in hydrogen? (remember nm is short for a nanometer, for example 656 nm = 656 x 10-9 meters) 656e-9 meters 486e-9 meters 434e-9 meters 410e-9 meters

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 17:00
The force it would take to accelerate an 900-kg car at the rate of 6m/s2
Answers: 1
question
Physics, 22.06.2019 18:30
An object in mechanical equilibrium is an object
Answers: 2
question
Physics, 22.06.2019 19:30
Ashot putter releases the shot some distance above the level ground with a velocity of 12.0 m/s, 51.0 ∘above the horizontal. the shot hits the ground 2.08 s later. you can ignore air resistance. how far did she throw the shot?
Answers: 2
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
As mentioned in this week’s notes on page 4, the electrons of an atom can occupy different energy sh...
Questions
question
Biology, 24.06.2021 23:40
question
Arts, 24.06.2021 23:40
question
Mathematics, 24.06.2021 23:50
question
History, 24.06.2021 23:50
question
Mathematics, 24.06.2021 23:50
Questions on the website: 13722363