Physics, 19.08.2019 22:30 Lilyy1k

Always use significant figure rules. remember that these rules apply to all numbers that are measurements.
a caterpillar tries to climb straight up a wall two meters high, but for every 2 cm up it climbs, it slides down 1 cm. eventually, it reaches the top. when it reaches the top, it does not pull itself over so it will slide down 1 cm. at this point, the caterpillar was exhausted and fell to the ground. what is the total displacement?
0 up
0 down
0 n/a
199 up
199 down
199 n/a
200 up
200 down
200 n/a

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 18:00

Assuming weightless pulleys and 100% efficiency, what is the minimum input force required to lift a 120 n weight using a single fixed pulley?

Answers: 2

Answer

Physics, 21.06.2019 20:30

F500 j of energy were added to 1 kg of each of these samples, which would experience the least temperature increase?

Answers: 2

Answer

Physics, 22.06.2019 03:50

A30 kg weight lies on top of a massless piston of area a = 0.01 m2 the exterior air is at a (constant) p =1 atm and t = 27 c. the interior gas is 0.4 moles of (ideal) n2 and it has initial temperature 27.00 degrees c. 1. what is the initial pressure in the interior? a. 29.4 kpa b. 130.7 kpa c. 101.3 kpa the next three questions concern what happens when an amount of heat q is slowly added to the interior, raising the piston by 1 mm and raising the interior temperature to 27.40 c

Answers: 3

Answer

Physics, 23.06.2019 00:00

You are standing on a boat. which of the following strategies will make the boat start moving? a. pushing the mast b. throwing some cargo out of the boat c. pushing the front ofthe boat d. pushing another passenger

Answers: 3

Answer

You know the right answer?

Always use significant figure rules. remember that these rules apply to all numbers that are measure...

Questions