Physics, 02.02.2022 07:50 rsloan13

Consider a pan placed on top of electric range to cook spaghetti. The bottom section of the pan is 0.4 cm thick and has a diameter of 18 cm. The electric heating unit on the range top consumes 800 W of power during cooking, and 80 percent of the heat generated in the heating element is transferred uniformly to the pan. Assuming constant thermal conductivity and steady state operation. The heat transfer can be approximated as being one- dimensional through the bottom surface to the top. Take the direction normal to the bottom surface to be the x-axis. Required:
a. Perform an energy balance on a thin element of the pan during a small-time interval △t , and indicate which terms may be neglected or ignored and why?
b. Assuming constant thermal conductivity, obtain the differential equation that describes the variation of the temperature in the bottom section of the pan during steady state operation.

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 19:30

A33.1 g copper object is launched from a 1.5 m 30° steel incline positioned on the floor by being pulled up a string attached to a 50.0 g mass suspended vertically over a pulley. the object is projected towards a glass table where it lands when it is at the point along its trajectory with the lowest speed. it comes to a halt when it clears the opposite edge of the table. it then falls and lands on 9 physics texts each 5 cm thick that are stacked on the floor on the opposite side of the table. assume that the table does not have a ledge and the rectangular object experiences 0.05 n of air resistance as it falls towards the books. how far and how long did the object travel and how fast does it hit the books. assume that at the moment the copper object leaves the incline, the massless string and ideal pulley break off

Answers: 2

Answer

Physics, 22.06.2019 02:30

Agas contained within a piston-cylinder assembly undergoes three processes in series: process 12: compression with pv= constant from 1 bar and 1 liter to 4 bar. process 23: constant pressure expansion to 1 liter. process 31: constant volume calculate the pressure and volume at each state, and sketch the processes on a p-vdiagram labeled with pressure and volume values at each numbered stat

Answers: 2

Answer

Physics, 22.06.2019 09:00

Abicycle slows down when the rider applies the brakes. what type of energy transformation is involved in this example? a. kinetic energy into heat energy b. heat energy into potential energy c. potential energy into kinetic energy d. kinetic energy into mechanical energy

Answers: 1

Answer

Physics, 22.06.2019 09:20

Question 11 of 13 (1 point) jump to question: a stairway, ladder, or ramp must be present in excavations in which of the following situations? a. all trenches must have access/egress b. the trench is more than 15 feet wide but only 1 ½ feet deep c. the trench is more than 4 feet deep and the devices must be within 25 feet of all workers

Answers: 1

Answer

You know the right answer?

Consider a pan placed on top of electric range to cook spaghetti. The bottom section of the pan is 0...

Questions