subject
Physics, 22.01.2022 06:50 gabrimccut

Suppose you display a 1 kHz, 2 V sine wave in channel A and a DC, 1V signal in channel B with sensitivities set on 1V/div. You select 'Add' so that the two signals are combined and you readjust the position so the trace is in the middle of the screen. If you switch the signal in channel B from DC to AC, what will happen? a. The trace jumps down 2 divisions.
b. The trace jumps down 1 division
c. The trace jumps up 1 division.
d. Nothing happens

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 19:30
Act has a 1200: 5 or 240: 1 turns ratio. it is short circuited. what is the maximum current at 1200a primary if we put a 100ohm resistor across the secondary end of the ct. use it as current source circuit.
Answers: 2
question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
question
Physics, 22.06.2019 05:40
Unpolarized light of intensity i_0=750w/m^2 is incident upon two polarizers. after passing through both polarizers the intensity is i_2=280w/m^2. (a) what is the intensity of the light after it passes through the first polarizer in w/m^2? (b) write an equation for the angle between the polarizers in terms of the initial (i_0) and final (i_2) intensities. (c) find the angle between the polarizers in degrees.
Answers: 3
question
Physics, 22.06.2019 11:00
Which sound characteristic is not affected by the relative motion of an object
Answers: 2
You know the right answer?
Suppose you display a 1 kHz, 2 V sine wave in channel A and a DC, 1V signal in channel B with sensit...
Questions
question
English, 15.12.2020 01:50
question
Mathematics, 15.12.2020 01:50
question
Mathematics, 15.12.2020 01:50
Questions on the website: 13722367