Physics, 14.01.2022 16:00 brandon436

The driver of a car traveling at 25.4 m/s applies the brakes and undergoes a constant deceleration of 3.17 m/s
How many revolutions does each tire make
before the car comes to a stop, assuming that
the car does not skid and that the tires have
radii of 0.37 m?
Answer in units of rev.

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 17:00

Heat from the sun reaches earth to a. radiation b. convection c. conduction

Answers: 2

Answer

Physics, 21.06.2019 17:20

American eels (anguilla rostrata) are freshwater fish with long, slender bodies that we can treat as uniform cylinders 1.0 m long and 10 cm in diameter. an eel compensates for its small jaw and teeth by holding onto prey with its mouth and then rapidly spinning its body around its long axis to tear off a piece of flesh. eels have been recorded to spin at up to 14 revolutions per second when feeding in this way. although this feeding method is costly in terms of energy, it allows the eel to feed on larger prey than it otherwise could. 1.a field researcher uses the slow-motion feature on her phones camera to shoot a video of an eel spinning at its maximum rate. the camera records at 120 frames per second. through what angle does the eel rotate from one frame to the next? 2. the eel is observed to spin at 14 spins per second clockwise, and 10 seconds later it is observed to spin at 8 spins per second counterclockwise. what is the magnitude of the eels average angular acceleration during this time? 3. the eel has a certain amount of rotational kinetic energy when spinning at 14 spins per second. if it swam in a straight line instead, about how fast would the eel have to swim to have the same amount of kinetic energy as when it is spinning? 4.a new species of eel is found to have the same mass but one-quarter the length and twice the diameter of the american eel. how does its moment of inertia for spinning around its long axis compare to that of the american eel?

Answers: 1

Answer

Physics, 22.06.2019 02:10

How is coal extracted from mountaintop removal mines? a. dynamite is used to create underground tunnels where miners go to extract the coal. b. dynamite is used to break apart rocks and then draglines are used to remove the broken rock and reach the coal. c. coal in mountaintops is extracted by digging strips in the landscape to reach the coal. d. placer deposits in mountain river bottoms are removed by

Answers: 2

Answer

Physics, 22.06.2019 03:00

An internally reversible refrigerator has a modified coefficient of performance accounting for realistic heat transfer processes of where qin is the refrigerator cooling rate, qout is the heat rejection rate, and is the power input. show that copm can be expressed in terms of the reservoir temperatures tc and th, the cold and hot thermal resistances rt,c and rt,h, and qin, as where rtot rt,c rt,h. also, show that the power input may be expressed as 1.39 a household refrigerator operates with cold- and hot-temperature reservoirs of tc 5 c and th 25 c, respectively. when new, the cold and hot side resistances are rc,n 0.05 k/w and rh,n 0.04 k/w, respectively. over time, dust accumulates on the refrigeratorâ€™s condenser coil, which is located behind the refrigerator, increasing the hot side resistance to rh,d 0.1 k/w. it is desired to have a refrigerator cooling rate of qin 750 w. using the results of problem 1.38, determine the modified coefficient of performance and the required power input w under (a) clean and (b) dusty coil conditions. internally reversible refrigerator qout qin w high-temperature reservoir low-temperature reservoir th th,i tc,i tc high-temperature side resistance low-temperature side resistance w qin th tc qinrtot tc qinrtot copm tc qinrtot th tc

Answers: 2

Answer

You know the right answer?

The driver of a car traveling at 25.4 m/s applies the brakes and undergoes a constant deceleration...

Questions