Physics, 14.12.2021 23:00 holman9308

A block of aluminum has dimensions 1m x 1m x .2m. The aluminum has a density of 2700kg/m^3. The block is submerged in a pool of water. How much force is required to lift it off the bottom of the pool (but still remain submerged)? Ive been struggling on this problem for awhile, to save you scrap work volume = .2m^3, mass= 540kg, and buoyancy force = 5292N. Not sure if any of that will help though.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 00:00

Name three different units of energy used to measure heat and describe what type of situations each is usually used.

Answers: 2

Answer

Physics, 22.06.2019 03:00

If a spring has a k value of 100 newtons per meter and it is stretched 0.50 meters, what is the restoring force of the spring?

Answers: 2

Answer

Physics, 22.06.2019 15:30

At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.

Answers: 1

Answer

Physics, 22.06.2019 18:50

8.29 two streams containing pyridine and acetic acid at 25°c are mixed and fed into a heat exchanger. due to the heat-of-mixing effect, it is desired to reduce the temperature after mixing to 25°c using a stream of chilled ethylene glycol as indicated in the diagram. calculate the mass flow rate of ethylene glycol needed. the heat capacity of ethylene glycol at these conditions is approximately 2.8 kj/(kg k), and the enthalpy change of mixing (δmixh) is given below.

Answers: 3

Answer

You know the right answer?

A block of aluminum has dimensions 1m x 1m x .2m. The aluminum has a density of 2700kg/m^3. The bloc...

Questions