subject
Physics, 08.12.2021 01:00 dargy

A science museum display about energy has a small engine that pulls on a rope to lift a block 1.00 m.
The display indicates that 1.00 J of work is done.
What is the mass of the block?

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
question
Physics, 22.06.2019 20:50
Suppose that a mass of 2 kg is attached a spring whose spring constant is 50. the system is damped such that b = 12 . the mass is set in motion with an initial velocity of -8 m/s at a position 0 meters from equilibrium. set up and solve a differential equation that models this motion. write your solution in the form a cos ( ω t − α ) where α is a positive number. use your solution to fill in the information below: what is the amplitude of the motion? what is the value of ω ? what is the phase shift?
Answers: 1
question
Physics, 22.06.2019 22:40
Which of the following is a direct benefit of the use of assembly lines in production a. laws against theft fraud and coercion are needed to protect free choice. b. the government needs to plan efficient outcomes. c. competition among producers by itself cannot ensure a wide range of consumer choices. d. works pressure the government to guarantee minimum wages
Answers: 2
question
Physics, 23.06.2019 00:20
An object with a mass of 1.5 kg changes its velocity from + 15 m/s to +22 m/s during a time interval of 3.5 seconds. what impulse was delivered to the objects?
Answers: 2
You know the right answer?
A science museum display about energy has a small engine that pulls on a rope to lift a block 1.00...
Questions
question
Mathematics, 04.03.2021 21:30
Questions on the website: 13722360