subject
Physics, 25.11.2021 14:10 ernestsbaby6181

you are given a graph of position versus time for the simple harmonic motion of a block-spring system. what would you change to change the range of the curve on the graph along the position axis?

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 07:00
Critical mass is the of material required to produce a chain reaction. a.) minimum amount b.) atomic mass c.) precise amount d.) maximum amount
Answers: 1
question
Physics, 22.06.2019 09:00
Agroup of students is studying convection currents. they fill two identical balloons with the same amount of helium. one balloon is placed in a freezer and the other in an area with warm air. after 10 minutes, the balloons are released from a height of 1 meter. which of the following do the students most likely observe? question 2 options: the balloons rise at the same rate. both balloons are the same size. the ballons both rise. the cold ballon is larger than the warm balloon. the cold balloon expands and rises. the warm balloon shrinks and sinks. the warm balloon expands and rises. the cold balloon shrinks and sinks.
Answers: 3
question
Physics, 22.06.2019 14:20
Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.
Answers: 1
question
Physics, 22.06.2019 16:30
Atank has a shape of a cone with a radius at the top of 2 m and a height of 5 m. the tank also has a 1 m spout at the top of the tank. the tank is filled with water up to a height of 2 m. find the work needed to pump all the water out the top of the spout. (use 9.8 m/s2 for g and the fact that the density of water is 1000 kg/m3.)
Answers: 1
You know the right answer?
you are given a graph of position versus time for the simple harmonic motion of a block-spring syste...
Questions
Questions on the website: 13722359