Acylindricaltankofradius5ftandheigh t9ftistwo-thirds filled with water. Find the work required to pump all the water over the upper rim.

Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.

Acommercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at -35°c by rejecting waste heat to cooling water that enters the condenser at 18°c at a rate of 0.25 kg/s and leaves at 26°c. the refrigerant enters the condenser at 1.2 mpa and 50°c. if the compressor consumes 3.3 kw of power, determine (a) the mass flow rate of the refrigerant, (b) the refrigeration load, (c) the cop, and (d) the minimum power input to the compressor for the same refrigeration load.

In which situation is the acceleration of a car negative? question 5 options: a)the velocity of a car was 75 km/hr over 4 hours. b)the velocity of a car reduced from 50 km/hr over one minute. c)the velocity of a car increased from 40 km.h to 75 km/h over 15 minutes. d)the velocity of a car was 45 km/hr at 2: 00pm and at 4: 00pm its velocity was 85 km/ht.