Derive an expression to find the surface tension of a liquid

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the answer is b ) square root of 5

see the picture for the vector

the magnitude of the vector by pythagorean theorem

r = √( (-10)^2 + (3)^2 ) = √109

magnitude = √109 units

the direction angle between vector and x-axis is

tan^(-1)(3/10) = 16.699

so the direction is approximately 16.7 degrees north of west

speed of light in vacuum is 300,000 km/s

speed of light in other mediums is given by the expression v = c/n, where c is the speed of light in vacuum and n is the refractive index of medium.

for the first medium v = 200,000 km/s

  so, refractive index of medium = 300000/200000 = 1.5

    1.5 refractive index is usually for glass. so first medium is glass.

for the second medium v = 250,00 km/s

so, refractive index of medium = 300000/250000 = 1.2

    1.2 refractive index is usually for water. so second medium is water.

for the third medium v = 0 km/s

so, refractive index of medium = 300000/0 = ∞

    ∞ refractive index is usually for opaque mediums. so third medium is opaque medium.