A worker takes a mixture of cast iron and steel metal and places it inside a furnace that reaches 1500°C. The molten cast iron is poured into a mold. The mold is hung out to dry. Later, the worker removes a cast iron skillet from the mold. What two phase changes occured in order to make the skillet?

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

12000j is work done

answer: the correct answer is 1.

explanation: there are various process in which a radioactive nuclei decays:

1) alpha decay: in this process, a heavier nuclei decays into lighter nuclei by releasing alpha particle. the mass number is reduced by 4 units.

2) electron capture: in this decay process, a parent nuclei absorbs an electron and gets converted into a neutron. simply, a proton and an electron combines together to form a neutron. mass number does not change in this process.

3) gamma ray emission: it is a decay process in which an unstable nuclei gives excess energy by a spontaneous electromagnetic process. this decay releases . this process does not change the mass number.

4) positron emission: it is a type of decay process, in which a proton gets converted to neutron and an electron neutrino. this is also known as -decay. in this the mass number remains same.

from the above information, we see that only alpha-decay is producing a change in the mass number of the nucleus.

he made 11 calls in one day