Pls help me find the answer. sorry it's a little bit blurry ​

What must be the same for any two resistors that are connected in series ? a. the potntial diffrence across each b. the rate at which charge moves through each c. the rate at which energy is used by each d. the resistance to the flow of charge of each

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Asailboat is traveling to the right when a gust of wind causes the boat to accelerate leftward at 2.5m/s2 for 4s. after the wind stops, the sailboat is traveling to the left with a velocity of 3.0m/s.assuming the acceleration from the wind is constant, what was the initial velocity of the sailboat before the gust of wind? answer using a coordinate system where rightward is positive.